YASKAWA iQpump1000 User Manual page 211

No.
A1-03
Note: 1. Settings 6012 and 6013 are available in drive software versions PRG: 8552 and later.
2. Setting 6014 is available in drive software versions PRG: 8553 and later.
3. Settings 6012, 6013, and 6014 are not available in drive models 4A0930 and 4A1200.
Setting 1110: User Initialize
Resets parameters to the values selected by the user as User Settings. User Settings are stored when parameter o2-03 is set to
"1: Set defaults".
Note: User Initialization resets all parameters to a user-defined set of default values previously saved to the drive. Set parameter o2-03 to 2 to
clear the user-defined default values.
Setting 2220: 2-Wire Initialization
Resets parameters to default settings with digital inputs S1 and S2 configured as Forward run and Reverse run, respectively.
Setting 3330: 3-Wire Initialization
Resets parameters to default settings with digital inputs S1, S2, and S5 configured as Run, Stop, and Forward/Reverse
respectively.
S1
SN
2-Wire Control
Notes on Parameter Initialization
The parameters shown in Table 4.17
No.
A1-00
E1-03
F6-08
L8-35
o2-04
Setting 5550: Terminal/Control Initialize
An oPE04 error appears on the digital operator when a terminal block with settings saved to its built-in memory is installed
in a drive that has edited parameters. Set A1-03 to 5550 to use the parameter settings saved to the terminal block memory.
Application Presets are available to facilitate drive setup for commonly used applications. Selecting one of these Application
Presets automatically assigns functions to the input and output terminals and sets a predefined group of parameters to values
appropriate for the selected application.
YASKAWA TOEP YAIP1W 01F YASKAWA AC Drive - iQpump1000 User Manual
4.7 Basic iQpump Setup and Application Preset Parameters
Parameter Name
Initialize Parameters
Stop switch
(NC contact)
FWD Run/Stop
Figure 4.30 2 & 3-Wire Control Wiring Examples
will not be reset when the drive is initialized by setting A1-03 = 2220 or 3330.
Table 4.17 Parameters Not Changed by Drive Initialization
Setting Range
0, 1110, 2220, 3330, 5550,
6008, 6009, 6010, 6011,
6012, 6013, 6014, 7770,
7771
Note:
Operation switch
(NO contact)
S1
S2
SN
3-Wire Control
Parameter Name
Language Selection
V/f Pattern Selection
Communication Parameter Reset
Installation Selection
Drive/kVA Selection
Default
A1-03 is initially
set to "6008" from
the factory,
although the
keypad will
always display
"0".
Run command
(Run on momentary close)
Stop command
(Stop on momentary open)
Sequence input common
0
4
211