YASKAWA iQpump1000 User Manual page 240

4.7 Basic iQpump Setup and Application Preset Parameters
Setting 2: Run Command
Triggers the digital output when there is an active Run command.
n P5-02: HAND Reference 1
Sets the frequency reference of HAND mode. When the drive is stopped, pressing the HAND key will start the drive and the
drive will accelerate to the P5-02 setting.
No.
P5-02
n P5-04: HAND Key Function Selection
Selects whether the HAND key on the HOA keypad is active. Disabling this function by setting P5-04 to 0 will prevent the
drive from entering HAND Mode.
No.
P5-04
Setting 0: Disabled
Setting 1: Enabled
n P6-12: Accumulation Level - Thousands
Sets the accumulated volume that will trigger the Accum Level alarm, Accum Level fault, or the Accum Level Fault – Auto
Flow Accum Reset.
No.
P6-12
n P6-15: Accumulation Behavior
Selects the drive response when the accumulated volume reaches the level set in parameters P6-11 to P6-14.
No.
P6-15
Setting 0: No display
Setting 1: Alarm only
Setting 2: Fault
Setting 3: Fault - Auto flow accum reset
Setting 4: Stop and alarm
Setting 5: Stop, alarm, and reset flow accumulation
n
P6-17: High Flow Level
Sets the level above which the flow must rise for longer than the time set in P6-18 to trigger a High Flow fault or alarm.
A setting of 0.0 disables High Flow detection.
No.
P6-17
n P6-19: High Flow Select
Determines drive response when a High Flow condition is detected.
No.
P6-19
240
Parameter Name
HAND Reference 1
Parameter Name
HAND Key Function Selection
Name
Accumulation Level - Thousands
Name
Accumulation Behavior
Name
High Flow Level
Name
High Flow Select
Setting Range
0.0 to E1-04
Setting Range
Setting Range
0 to 999
Setting Range
Setting Range
0.0 to 6000.0
Setting Range
YASKAWA TOEP YAIP1W 01F YASKAWA AC Drive - iQpump1000 User Manual
Default
40.0 Hz
Default
0, 1
Default
0 gal
Default
0 to 5
Default
0.0 GPM
Default
0 to 3
1
1
1