YASKAWA iQpump1000 User Manual page 41

Installation
Method
Simplified installation with the
External/ HOA keypad is mounted on the
Face-Mount outside of the panel with two
screws.
Encloses the HOA keypad in
Internal/ the panel. The front of the HOA
Flush-Mount keypad is flush with the outside
of the panel.
NOTICE: Prevent foreign matter such as metal shavings or wire clippings from falling into the drive during installation and project
construction. Failure to comply could result in damage to the drive. Place a temporary cover over the top of the drive during installation.
Remove the temporary cover before drive start-up, as the cover will reduce ventilation and cause the drive to overheat.
External/Face-Mount
1.
Cut an opening in the enclosure panel for the HOA keypad as shown in
2.
Position the HOA keypad so the display faces outwards, and mount it to the enclosure panel as shown in
2.12.
Internal/Flush-Mount
An internal/flush-mount requires an installation support set that must be purchased separately. Contact Yaskawa to order an
installation support set and mounting hardware.
1.
Cut an opening in the enclosure panel for the HOA keypad as shown in
2.
Mount the HOA keypad to the installation support.
3.
Mount the installation support set and HOA keypad to the enclosure panel.
YASKAWA TOEP YAIP1W 01F YASKAWA AC Drive - iQpump1000 User Manual
Table 2.2 HOA Keypad Installation Methods and Required Tools
Description
Support Sets
Installation Support Set A
(for mounting with screws
through holes in the panel)
Installation Support Set B
(for use with threaded studs
that are fixed to the panel)
Figure 2.11 Panel Cut-Out Dimensions (External/Face-Mount Installation)
HOA Keypad
Figure 2.12 External/Face-Mount Installation
Figure 2.13
Installation
–
EZZ020642A
EZZ020642B
22 (0.87)
22 (0.87)
Unit: mm (in)
14 (0.56)
M3 x 6
Phillips recessed
pan head machine screw x 2
Enclosure panel
illustrates how to attach the Installation Support Set A.
2.1 Mechanical Installation
Model Required Tools
Phillips screwdriver
–
Phillips screwdriver
Phillips screwdriver (#1)
Wrench (7 mm)
Figure 2.11.
Figure 2.14.
(#1)
(#1, #2)
Figure
2
41