YASKAWA iQpump1000 User Manual page 140

4.4 Using the HOA Keypad
u
LCD Display
No. Name
1 Operation Mode Menus
2 Mode Display Area
3 Ready
4 Data Display
Frequency
Reference
5
<1>
Assignment
LOCAL/REMOTE
6
<2>
Display
Function Key 2
7
(F2)
140
Figure 4.3 LCD Display
Table 4.3 Display and Contents
Display
MODE Displayed when in Mode Selection.
QMONI: Use F1/F2 Instructions to access the Quick Monitors.
MENU: Use UP/
Instructions to access the next menu item.
DWN
MONITR Displayed when in Monitor Mode.
VERIFY Indicates the Verify Menu.
PRMSET Displayed when in Parameter Setting Mode.
A.TUNE Displayed during Auto-Tuning.
SETUP Displayed when in Setup Mode.
DRV Displayed when in Drive Mode.
PRG Displayed when in Programming Mode.
Rdy Indicates the drive is ready to run.
— Displays specific data and operation data.
OPR Displayed when the frequency reference is assigned to the HOA keypad.
Displayed when the frequency reference is assigned to the MEMOBUS/Modbus
COM
Communication Inputs of the drive.
OP Displayed when the frequency reference is assigned to option card connected to the drive.
AI Displayed when the function reference is assigned to an analog input.
OFF Displayed when HAND mode is OFF.
Displayed when the Run command is supplied from a remote source.
RSEQ
Note:
LSEQ Displayed when the Run command is supplied from the HOA keypad.
Displayed when the Run command is supplied from a remote source.
RREF
Note:
LREF Displayed when the Run command is supplied from the HOA keypad.
<-MONITOR->
Pressing
DATA
Pressing
→
Pressing
RESET
Pressing
Monitor
Pressing
Content
This display will blink when b1-02 is set to 1 (Digital Inputs).
This display will blink when b1-01 is set to 1 (Analog Inputs).
F2
displays the next Quick Monitor.
F2
scrolls to the next display.
F2
scrolls the cursor to the right.
F2
resets the existing drive fault error.
F2
switches Monitor mode.
YASKAWA TOEP YAIP1W 01F YASKAWA AC Drive - iQpump1000 User Manual