F-Series Endpoints - Receiver Operation Mode - Lightware UBEX-PRO20-HDMI-F110 User Manual

 
     
3. Installation 3. Installation
3.3.2. F-series Endpoints - Receiver Operation Mode
Connections for the F110 model in receiver operation mode
Changing the Operation Mode
The operation mode of the UBEX endpoint device can be changed using the following methods:
via front panel LCD menu - see the details in the
▪
▪ via Lightware Device Controller (LDC) software - see the details in the
▪ via LW3 protocol command - see the details in the
UBEX series – Extender Application Mode – User's Manual UBEX series – Extender Application Mode – User's Manual
Operation Mode section;
Status Tab section;
Set the Operation Mode section.
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | LDC software: v1.34.0b2
Connect singlemode or multimode (depends on the installed SFP+ modules) fiber
OPT
DAC optical cables or DAC cables between the two UBEX endpoint devices. The Extender
Mode is detected and applied automatically in the device once the connection is
established successfully.
HDMI out Connect the sink devices (e.g. monitor, projector) to the HDMI output 1 and 2 ports
by HDMI cables.
Optionally connect the receiver to a LAN in order to control the device.
Ethernet
Power
Connect the power adaptor to the AC input on the receiver first, then to the AC power
socket.
Audio in
Connect an audio source device (e.g. MP3 player) to the audio input connector.
Audio out Connect an audio sink device (e.g. audio amplifier) to the audio output connector.
IR in Connect an Infrared detector unit to the IR IN connector for receiving Infrared input
signal.
IR out
Connect an Infrared emitter unit to the IR OUT connector for controlling third-party
devices over Infrared signal.
RS-232 Optionally for RS-232 extension: connect the controlled unit (e.g. projector) to the
RS-232 port of the device with a serial cable.

WARNING! User Ethernet is also transmitted over the SFP+ interface so be sure not to create network
loop!
INFO:
The HDMI input ports cannot accept AV signals when the device is configured as receiver.
24 24