F-Series Endpoints - Receiver Operation Mode - Lightware UBEX Series User Manual

 
     
3. Installation 3. Installation
3.4.2. F-series Endpoints - Receiver Operation Mode
Connections for the F110 model in receiver operation mode
Changing the Operation Mode
The operation mode of the UBEX endpoint device can be changed using the following methods.
Before connecting the device to the network and the MMU:
▪ via front panel LCD menu;
After connecting the device to the network and the MMU:
▪ via Lightware Device Controller (LDC) software - see the details in the
▪ via LW3 protocol command - see the details in the
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | Applied MMU firmware package: v1.2.1 | LDC software: v1.34.0b2
UBEX series – Matrix Application Mode – User's Manual UBEX series – Matrix Application Mode – User's Manual
Device Map section;
Set the Operation Mode section.
Connect singlemode or multimode (depends on the installed SFP+ modules) fiber
OPT
optical cables or DAC cables between the receiver and the Layer 3 (L3) network
DAC
switch. The Matrix Mode is detected and applied automatically in the device once
the MMU claims the endpoint.
HDMI out Connect the sink devices (e.g. monitor, projector) to the HDMI output 1 and 2 ports
by HDMI cables.
Ethernet Optionally connect the receiver to a LAN in order to control the device.
Power
Connect the power adaptor to the AC input on the receiver first, then to the AC power
socket.
Audio in Connect an audio source device (e.g. MP3 player) to the audio input connector.
Audio out Connect an audio sink device (e.g. audio amplifier) to the audio output connector.
IR in
Connect an Infrared detector unit to the IR IN connector for receiving Infrared input
signal.
IR out
Connect an Infrared emitter unit to the IR OUT connector for controlling third-party
devices over Infrared signal.
RS-232 Optionally for RS-232 extension: connect the controlled unit (e.g. projector) to the
RS-232 port of the device with a serial cable.

WARNING! User Ethernet is also transmitted over the SFP+ interface so be sure not to create network
loop!
INFO:
The HDMI input ports cannot accept AV signals when the device is configured as receiver.
28 28