Stopbits Setting; Parity Setting; Operation Mode; Command Injection Enable - Lightware UMX-TPS-TX120 User Manual


  
7. LW3 Programmers' Reference
7.17.4. Stopbits Setting
Command and Response
SET·/MEDIA/UART/<port>.StopBits=<stopbits>
ç
pw·/MEDIA/UART/<port>.StopBits=<stopbits>
æ
Parameters
Identifier Parameter description
<stopbits> Stopbits value
Example
ç SET /MEDIA/UART/P1.StopBits=0
æ pw /MEDIA/UART/P1.StopBits=0
7.17.5. Parity Setting
Command and Response
ç SET·/MEDIA/UART/ <port>.Parity=<parity>
pw·/MEDIA/UART/<port>.Parity=<parity>
æ
Parameters
Identifier Parameter description
<parity>

Parity setting

Example
ç SET /MEDIA/UART/P1.Parity=0
æ pw /MEDIA/UART/P1.Parity=0
Value Parameter value
0 1
1 1,5
2 2
Value Parameter value
0 None
1 Odd
2 Even
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
UMX-TPS-TX100 series – User's Manual
7.17.6. RS-232 Operation Mode
Command and Response #rs232 #rs-232 #serial #commandinjection
SET·/MEDIA/UART/<port>.Rs232Mode=<mode>
ç
pw·/MEDIA/UART/<port>.Rs232Mode=<mode>
æ
Parameters
Identifier Parameter description
<stopbits>
Example
ç SET /MEDIA/UART/P1.Rs232Mode=1
æ pw /MEDIA/UART/P1.Rs232Mode=1

INFO: See more information about RS-232 modes in the
7.17.7. Command Injection Enable
Command and Response
SET·/MEDIA/UART/<port>.CommandInjectionEnable=<logical_value>
ç
pw·/MEDIA/UART/<port>.CommandInjectionEnable=<logical_value>
æ
Parameters
Identifier Parameter description
Command injection
<logical_value>
enable/disable setting
Example
ç SET /MEDIA/UART/P1.CommandInjectionEnable=true
æ pw /MEDIA/UART/P1.CommandInjectionEnable=true
INFO:
The Command
/MEDIA/UART/<serial_port>.CommandInjectionStatus.
Value
0 Pass-through
Stopbits value 1 Control
2 Command injection
Technical Background
Value
true Command injection is enabled.
false Command injection is disabled.
injection status is stored in another
131
Parameter value
section.
Parameter value
read-only property: