Assembly Guides; Front Plate Exchange For F-Series Endpoint Devices; Tool Requirements; The Steps Of The Front Plate Exchange - Lightware UBEX-PRO20-HDMI-F110 User Manual

 
     

11. Assembly Guides

11. Assembly Guides
11
Assembly Guides
This chapter contains step-by-step assembly guides for the UBEX series
devices like the following:
ç Front Plate Exchange for F-series Endpoint Devices
ç Hidden USB Connector for Debug Purpose
ç SFP+ Module Changing in R-series Endpoints
UBEX series – Extender Application Mode – User's Manual UBEX series – Extender Application Mode – User's Manual
11.1. Front Plate Exchange for F-series Endpoint
Devices
The section is about the assembling of the UBEX F-series endpoint
devices which contains detailed step-by-step guides and the tool
requirements.
Affected Models
The front plate can be changed on the following endpoint models:
▪ UBEX-PRO20-HDMI-F100
▪ UBEX-PRO20-HDMI-F110
11.1.1. Tool Requirements
Plastic spudger tool
11.1.2. The Steps of the Front Plate Exchange
Removal of the Front Plate
Step 1. Remove the rubber ring carefully from the jog dial knob using
the plastic spudger tool.
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | LDC software: v1.34.0b2
1.3 mm hex wrench PZ1 screwdriver
(Allen) key
Step 2. Find the screw in the side of the jog dial knob and use a 1.3 mm
hexagon (Allen) wrench key to loosen it.
Step 3. Pull down the jog dial knob from the holder.
Step 4. Remove all the six screws from the front plate using the PZ1
screwdriver.
121 121