Assembly Guides; Front Plate Exchange For F-Series Endpoint Devices; Tool Requirements; The Steps Of The Front Plate Exchange - Lightware UBEX Series User Manual

 
     

13. Assembly Guides

13. Assembly Guides
13
Assembly Guides
This chapter contains step-by-step assembly guides for the UBEX series
devices like the following:
ç Front Plate Exchange for F-series Endpoint Devices
ç Hidden USB Connector for Debug Purpose
ç SFP+ Module Changing in R-series Endpoints
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | Applied MMU firmware package: v1.2.1 | LDC software: v1.34.0b2
UBEX series – Matrix Application Mode – User's Manual UBEX series – Matrix Application Mode – User's Manual
13.1. Front Plate Exchange for F-series Endpoint
Devices
The section is about the assembling of the UBEX F-series endpoint
devices which contains detailed step-by-step guides and the tool
requirements.
Affected Models
The front plate can be changed on the following endpoint models:
▪ UBEX-PRO20-HDMI-F100
▪ UBEX-PRO20-HDMI-F110
13.1.1. Tool Requirements
Plastic spudger tool 1.3 mm hex wrench
(Allen) key
13.1.2. The Steps of the Front Plate Exchange
Removal of the Front Plate
Step 1. Remove the rubber ring carefully from the jog dial knob using
the plastic spudger tool.
Step 2. Find the screw in the side of the jog dial knob and use a 1.3 mm
hexagon (Allen) wrench key to loosen it.
Step 3. Pull down the jog dial knob from the holder.
PZ1 screwdriver
Step 4. Remove all the six screws from the front plate using the PZ1
screwdriver.
179 179