Table of Contents
Advertisement
3. Installation
3.4. Connecting Steps
DP
Connect the desired source to the DP input port of the transmitter.
USB
Connect the supplied USB cable between the transmitter and a computer to extend USB HID
devices, to connect local USB devices, and/or to control the extenders by LDC.
USB
Connect the desired local USB devices to the Transmitter and USB HID devices to the Receiver for
USB KVM extension.
DP
Connect a DP sink device to the Receiver by a DP cable or an HDMI sink device by an HDMI cable
and a DP/HDMI adaptor cable.
Connect a multimode fiber optical cable between the transmitter and the receiver.
Connect the power adaptor to the DC input on the receiver first, then to the AC power socket or use
Lightware's rack-mountable Power Supply Units.
DP-OPT-TX150, DP-OPT-RX150 – User's Manual
3.5. Powering On
ATTENTION!
before connecting them. Powered on devices may have dangerous voltage levels which can damage
sensitive electronic circuits.
After the system is complete, connect the DC power cable to the extender unit and then to the power outlet.
The unit is immediately powered ON.
After the extender units are initialized, the attached DP source and monitor can be powered on.
ATTENTION!
further use is not advised. Please contact support@lightware.com.
INFO:
laser loss problems.
3.5.1. Setting up USB Devices
DP-OPT-RX150 handles USB HID devices (Human Interface Device), which are input devices like mouse,
keyboard, presenter, pointing device, etc. However USB HUBs are supported (like those keyboards, monitors
that have built-in USB HUB), only two devices are available for extension at the same time.
When the transmitter is connected to the computer by the USB cable, it can be used as a local USB 2.0 HUB.
To build the USB connection, do the following steps:
Step 1. Connect the supplied USB cable to the transmitter's mini USB connector.
Step 2. Connect the other end of the USB cable into an empty USB slot on the computer.
Step 3. Connect the HID device(s) to the receiver.
INFO:
be handled as new hardware by the operating system at the first time.
Applied firmware package: v1.1.13 | LDC software: v2.5.1b5
When building an electronic system, make sure that all of the devices are powered down
If the power LED does not light up upon power-up, the unit is most likely damaged and
The laser becomes enabled any time the transmitter is powered on. This is done to avoid accidental
If the previously used USB devices are connected through the extenders to the computer, they may
13
Advertisement
Table of Contents
