Selecting The Communications Interface For Wagoframe; Figure 40: The Dtm For The Interface Configuration (Example) - WAGO -SPEEDWAY 767 Manual

154 Parameterization via WAGOframe
15.4.2

Selecting the Communications Interface for WAGOframe

This chapter is only relevant if you use "Online Parameter Setting".
Requirement:
The fieldbus coupler must be switched on and your PC must be connected with
the USB interface. For more information, see section "Connection to the Data and
Supply Cable" > "Connecting the USB Cable".
1. Double-click on the "WAGO Service Speedway" DTM in the "Network
View" pane. The DTM for the interface configuration opens.
2. Select the COM port that you use from the Interface selection box. If the
list of available interfaces is empty, check whether the fieldbus coupler is
switched on and connected to your PC via the USB cable.
If you establish the connection via [Go online] later, the COM port is
checked. If it is incorrect, it is automatically selected.
3. Click [Apply] and then [Close].

Figure 40: The DTM for the interface configuration (example)

WAGO-SPEEDWAY 767
767-1201 FC PROFINET IO 8DI 24V DC
Manual
Version 2.2.0