Ethernet" View; Table 28: Parameter Description Of The Page "Ethernet - WAGO -SPEEDWAY 767 Manual

70 Commissioning
7.3.2

"ETHERNET" View

The "ETHERNET" page contains information about the physical connection to
the connected ETHERNET network. The value displayed cannot be changed.
The following table explains the parameters listed on the site:

Table 28: Parameter description of the page "ETHERNET"

ETHERNET Details
MAC Address
ETHERNET Port Details
MAC Address
Link state
Link speed
Link mode
Autonegotiation
Auto MDIX
767-1201 FC PROFINET IO 8DI 24V DC
Displays the MAC address, which helps identify and address the
fieldbus coupler.
ETHERNET Port FB1
Displays the both port MAC address.
Displays the current link status (up/down) of the port.
Displays the current transmission rate of the ETHERNET
network; if you want data exchange via a fieldbus controller, you
must operate the fieldbus coupler in a full-duplex network with
100 Mbit/s.
Displays the current transmission mode of the ETHERNET
network; if you want data exchange via a fieldbus controller, you
must operate the fieldbus coupler in a full-duplex network with
100 Mbit/s.
Displays whether the automatic search for the optimal
ETHERNET speed is activated.
Displays if the Auto MDI-X function of the ETHERNET
connection is enabled or disabled; the function employs an
internal switching functionality to allow use of either crossed
(cross-over) or straight-in (patch) cables.
WAGO-SPEEDWAY 767
ETHERNET Port FB2
Manual
Version 2.2.0