Diagnostic Overview And Parameters Of Inputs; Figure 77: Diagnostic Overview Of The Fieldbus Coupler (Example); Table 102: Diagnostic Setup - WAGO -SPEEDWAY 767 Manual

WAGO-SPEEDWAY 767
767-1201 FC PROFINET IO 8DI 24V DC
Pos : 55.39 /Serie 767 ( WAGO-SPEED WAY)/Parametrier en/F eldbus koppler/Di agnoseübersic ht, Ei ngänge, Gl obale Ei nstellungen, F el dvers orgung @ 7\mod_1269255974080_21.doc x @ 53669 @ 3 @ 1
15.7.3

Diagnostic Overview and Parameters of Inputs

Diagnostic Overview
The currently pending diagnostics existing on the module are displayed here. In
this view of the DTM, you can enable simulation of the diagnostics, as well as
disable transmission of the diagnostics. When disabling transmission, make sure
that the display behavior of each LED changes that indicates the specific
diagnostics (section "Operational Messages of the Fieldbus Coupler via LED
Signals").
The diagnostic overview is only available in online mode.

Figure 77: Diagnostic overview of the fieldbus coupler (example)

Table 102: Diagnostic setup

Parameter
Insert in PI
Simulation
Status
Manual
Version 2.2.0
Parameterization via WAGOframe
Description
This parameter disables/enables transmission of diagnostics.
Doing so has no effect on the size of the process image, but does
affect its content.
If you have selected the "Insert in PI" checkbox, the "Simulation"
parameter is released. You can select the diagnostics you want to
simulate. Click the [Write] button to transfer the simulated values to
the module.
Displays whether there is a diagnostics:
X mark: There is a diagnostic message.
Check mark: There is no diagnostic message.
193