Pos : 27.1 /All e Seri en ( Allgemei ne Module)/Ü bers chriften/N eue Ü berschriften/Ebene 1In Betrieb nehmen - Übersc hrift 1 @ 4\mod_1240901452750_21.doc x @ 31570 @ 1 @ 1

Commissioning

Pos : 27.2 /Serie 767 (WAGO-SPEED WAY)/Wic htige Erläuterungen/Sicherheits hinweis e/Achtung/Achtung: Offene Ansc hlüss e @ 8\mod_1278308159953_21.doc x @ 58910 @ @ 1

Exposed connections!

If connections have not been closed with protective caps, liquid or dirt can

penetrate the components of the 767 Series module and ruin it. Therefore, close

all unnecessary connections with protective caps, which must be ordered

separately, in order to maintain the IP67 degree of protection. (See section

"Accessories" of the fieldbus coupler/controller manual.)

Pos : 27.3 /Serie 767 (WAGO-SPEED WAY)/In Betrieb nehmen/Fel dbus koppl er/Inbetri ebnahme allgemei n @ 7\mod_1268919059753_21.doc x @ 53597 @ @ 1

Before starting up the 767 node, ensure that the following requirements are met:

•

The fieldbus coupler is mounted properly (see section "Mounting the

Fieldbus Coupler").

•

All necessary supply and sensor lines, as well as the S-BUS and fieldbus

cable, are securely fastened onto the appropriate connections

(see section "Connection to the Data and Supply Cable").

•

The S-BUS terminator is fastened (see section "Connecting Data and

Supply Cables").

•

An appropriate potential equalization is implemented in your system.

•

The shielding is carried out properly.

Pos : 27.4 /Serie 767 (WAGO-SPEED WAY)/In Betrieb nehmen/Fel dbus koppl er/Inbetri ebnahme 767-1201, -1301, -1311, - 1401, -1501 @ 8\mod_1279524134190_21.doc x @ 60324 @ @ 1

•

The power supply of the higher-level controller is switched on (see

associated manual).

Pos : 27.5 /Dokumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1

WAGO-SPEEDWAY 767

767-1201 FC PROFINET IO 8DI 24V DC

Manual

Version 2.2.0

Table of Contents