Figure 19: S-Bus Is Connected To One Fieldbus Coupler And Two I/O Modules - WAGO -SPEEDWAY 767 Manual

WAGO-SPEEDWAY 767
767-1201 FC PROFINET IO 8DI 24V DC
To connect the S-BUS cable to fieldbus couplers and I/O modules, proceed as
follows:
1. Disconnect the power supply from those devices on which you have
mounted the fieldbus coupler.
2. Connect the S-BUS cable (S1) with the OUT connection
fieldbus coupler and the IN connection
For example, if two I/O modules have been connected to the fieldbus
coupler, connect the S-BUS cables (S1, S2) to the associated IN and OUT
connections, as shown in the following figure.
3. Tighten the plugs and sockets using the knurled-head screws.
4. Attach the S-BUS terminator (T) to the last I/O module as shown in the
figure and tighten it.
Pos : 25.16 /Serie 767 ( WAGO-SPEED WAY)/Ansc hluss D aten- und Versorgungs kabel/F eldbus koppler/Ansc hluss _S-BUS ETH ERN ET-Fel dbus koppl er @ 8\mod_1279802895669_21.doc x @ 60854 @ @ 1
If you do not connect any I/O modules to the S-BUS, screw the S-BUS terminator
(T) onto the S-BUS OUT output
Pos : 25.17 /Serie 767 ( WAGO-SPEED WAY)/Ansc hluss D aten- und Versorgungs kabel/F eldbus koppler/Ansc hluss _S-BUS 767-1301 - Bild @ 8\mod_1279803585004_21.doc x @ 60858 @ @ 1

Figure 19: S-BUS is connected to one fieldbus coupler and two I/O modules

Pos : 25.18 /D okumentati on allgemei n/Gli ederungsel emente/---Seitenwec hs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Manual
Version 2.2.0
Connecting Data and Supply Cables
(3) of the fieldbus coupler.
3
(3) of the
(8) of the subsequent I/O module.
8
57