Table of Contents
Advertisement
WAGO-SPEEDWAY 767
767-1201 FC PROFINET IO 8DI 24V DC
To connect the supply cable to the fieldbus coupler and I/O modules, proceed as
follows:
1.
Disconnect the power supply from those devices on which you have
mounted the fieldbus coupler.
2.
Connect the power supply cable (K0) with the fieldbus coupler by plugging
the socket in the IN connection
3.
Tighten the socket using the knurled-head screw.
4.
Connect the power supply transmission cable (K1) with the OUT
connection
the subsequent I/O module.
For example, if two I/O modules have been connected to the fieldbus
coupler, connect the power supply transmission cables (K1, K2) to the
associated IN and OUT connections as shown in the following figure.
5.
Tighten the plugs and sockets using the knurled-head screw.
Pos : 25.20 /Serie 767 ( WAGO-SPEED WAY)/Ansc hluss D aten- und Versorgungs kabel/F eldbus koppler/Ansc hluss _Spannungs vers orgung - Bild @ 7\mod_1268906370024_21.doc x @ 53466 @ @ 1
6
Figure 20: Supply cable connected with fieldbus coupler and I/O modules
Pos : 25.21 /D okumentati on allgemei n/Gli ederungsel emente/---Seitenwec hs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Manual
Version 2.2.0
(6) of the fieldbus coupler.
(5) of the fieldbus coupler and the IN connection
5
Connecting Data and Supply Cables
8
59
(8) of
Advertisement
Chapters
Table of Contents
