Pos : 23.8 /Serie 767 (WAGO-SPEED WAY)/M ontier en/Fel dbus koppl er/Montage_Direktmontage 767- xxxx_F el dbus koppl er_1 @ 7\mod_1268894152141_21.doc x @ 53386 @ 2 @ 1

5.3

Direct Mounting on Your System

Mount the fieldbus coupler directly on a level surface of your system, without

using WAGO accessories. Direct mounting of the fieldbus coupler is to be carried

out as follows:

Disconnect the power supply from those devices on which you wish to

mount the fieldbus coupler.

Mark the drill holes using the hole drilling template printed on the

packaging. You can also hold the fieldbus coupler in the desired position

and mark the drill holes. Ensure that there is sufficient space around the 767

Series component to enable you to connect all cable without problems.

Pos : 23.9 /Serie 767 (WAGO-SPEED WAY)/Wic htige Erläuterungen/Sicherheits hinweis e/Hi nweis /Hinweis: 767- xxxx Distanzstüc k @ 8\mod_1279025151416_21.doc x @ 59810 @ @ 1

Direct Mounting

We recommend using WAGO spacers for compact direct mounting. If these are

used, the resulting additional distance from the second 767 Series component is to

be noted. See section "Mounting the Module" > "Mounting the Spacer in the Case

of Compact Arrangement".

Pos : 23.10 /Serie 767 ( WAGO-SPEED WAY)/Monti eren/F eldbus koppler/M ontage_Dir ektmontag e 767- xxxx_F eldbus koppler _2 @ 8\mod_1279027107838_21.doc x @ 59816 @ @ 1

Fasten the fieldbus coupler to the grounded frame of your system or to

another grounding point with the M4x12 screws via the three mounting

holes.

Pos : 23.11 /Serie 767 ( WAGO-SPEED WAY)/Monti eren/F eldbus koppler/M ontage_Dir ektmontag e 767- xxxx_F eldbus koppler - Bild @ 7\mod_1268894152578_21.doc x @ 53390 @ @ 1