Snmp" View; Table 31: Parameter Description Of The Page "Snmp - WAGO -SPEEDWAY 767 Manual

72 Commissioning
7.3.5

"SNMP" View

The SNMP V1 and V2c network management protocols are configured on this
page.
1. To confirm your entries, click [SUBMIT].
To clear your entries, click [RESET].
2.
3. Your entries are not active until the software has been reset. To reset the
software, click on "Administration" in the navigation bar and then
[Software Reset].
Alternatively, reset the software be cycling the system power supply.

Table 31: Parameter description of the page "SNMP"

SNMP Configuration
Entry
System Description
System Location
(physical)
System Contact
SNMP V1/V2 Manager Configuration
Entry
Protocol Enable
Local Community
Name
SNMP V1/V2 Trap Receiver Configuration
Entry
Trap Receiver 1
Community Name 1 public
Trap Version 1
Trap Receiver 2
Community Name 2 public
Trap Version 2
Value (Default) Description
WAGO 0767-1201 Device name (sysName)
FC PROFINET IO
Location of device (sysLocation)
local
support@wago.com E-mail contact address (sysContact)
Value (Default) Description
Activating SNMP Version 1/2c

SNMP

V1/V2c
Deactivating SNMP-Version 1/2c

Used community name
public
Value (Default) Description
0.0.0.0 IP address of 1. used SNMP manager
1. Community name of the network community used

V1

V1
V2

V1

IP address of 2. used SNMP manager
0.0.0.0
2. Community name of the network community used
V1 
V1 
V2

V1

WAGO-SPEEDWAY 767
767-1201 FC PROFINET IO 8DI 24V DC
Activating Traps Version 1
V2

Activating Traps Version 2
V2 
Activating Traps Version 1
V2

Activating Traps Version 2

V2
Manual
Version 2.2.0