Tcp/Ip" View; Port" View; Table 29: Parameter Description Of The Page "Tcp/Ip; Table 30: Parameter Description Of The Page "Port - WAGO -SPEEDWAY 767 Manual

WAGO-SPEEDWAY 767
767-1201 FC PROFINET IO 8DI 24V DC
7.3.3

"TCP/IP" View

This page displays the TCP/IP settings.
You can use a project tool to change the configuration via the DCP protocol.
The following table explains the parameters listed on the site:

Table 29: Parameter description of the page "TCP/IP"

Active used IP configuration
IP address
Subnet mask
Gateway
Permanent stored IP configuration
IP address
Subnet mask
Gateway
7.3.4

"Port" View

On this page for the protocol configuration, select the protocol that you would like
to use for communication.
To confirm your entries, click [SUBMIT].
1.
2. To clear your entries, click [RESET].
3. Your entries are not active until the software has been reset. To reset the
software, click "Administration" in the navigation bar and then [Software
Reset].
Alternatively, reset the software be cycling the system power supply.

Table 30: Parameter description of the page "Port"

Port Settings
FTP
HTTP
SNMP
WAGO Services
Manual
Version 2.2.0
Displays the current IP address of the fieldbus coupler.
Displays the current subnet mask of the fieldbus coupler.
Displays the current gateway address of the fieldbus coupler.
Displays the IP address of the fieldbus coupler stored in non-
volatile memory.
Displays the subnet mask of the fieldbus coupler stored in non-
volatile memory.
Displays the gateway address of the fieldbus coupler stored in
non-volatile memory.
When this checkbox is selected, the protocol for file transfer is
active.
Default setting: active
When this checkbox is selected, the Webserver (WBM) is active.
Default setting: active
Notice! By disabling the port, you are no longer able to reach the
device WBM after restarting the device. To enable the port again
later, use the "WAGOframe" programming tool
(ETHERNET/IPV4/WEB-Server-Configuration).
When the checkbox is selected, the device's SNMP functionality
is available.
Default setting: active
When the checkbox is selected, the service protocol is available
via TCP ("WAGOframe").
Default setting: active
Commissioning 71