Table 79: Group Number 5: General Internal Hardware Errors; Table 80: Group Number 6: General Internal Hardware Warnings - WAGO -SPEEDWAY 767 Manual

WAGO-SPEEDWAY 767
767-1201 FC PROFINET IO 8DI 24V DC

Table 79: Group Number 5: General Internal Hardware Errors

Error code Error argument Cause
1
2
3
4
5
6
7
...
18

Table 80: Group Number 6: General Internal Hardware Warnings

Error code Error argument Cause
1
Pos : 52.22 /D okumentati on allgemei n/Gli ederungsel emente/---Seitenwec hs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Manual
Version 2.2.0
1
Error when accessing flash
memory.
2
Error when initializing the
7
USB stack.
1
EEPROM error
2
3
Real-time clock (RTC) is
defective.
4
1
2 RAM error
3
1
2
3
4
Error in internal
1 coprocessor.
2
3
4
Combination of hardware
1
and software not allowed.
9 EEPROM error
255 Internal fault
Fieldbus coupler has not
been connected to power
1
supply for six days (back-up
capacitor of RTC empty).
Diagnostics
Correction
Perform a restart by disconnecting
the power supply and then
reconnecting it.
Contact WAGO support.
Perform a restart by disconnecting
the power supply and then
reconnecting it. If you cannot
eliminate the error, please contact
WAGO support.
Perform a firmware update on the
fieldbus coupler
Perform a restart by disconnecting
the power supply and then
reconnecting it.
These blink codes assist the support
team in further error investigation.
Please be ready to give them the
group number, error code and error
argument.
Correction
Set the real-time clock via
WAGOframe.
141