Pos : 55.3 /Serie 767 (WAGO-SPEED WAY)/Par ametrieren/F eldbus koppler /Aus wahl Sc an 1.0 Ei nleitung +Busadresse @ 8\mod_1279532795560_21.doc x @ 60415 @ 2 @ 1

15.6

The "Additional Functions" and "Scan" Selections

Requirement:

You have switched on the fieldbus coupler, connected your PC with the USB

connection and established a communication link to the 767 components ("Go

online" in the context menu).

The "Additional Functions" selection from the context menu provides the

following additional functionalities in addition to the possibility of

parameterization:

•

Change bus address

Here you can change the S-BUS addresses for individual I/O modules.

Pos : 55.4 /Serie 767 (WAGO-SPEED WAY)/Par ametrieren/F eldbus koppler /Aus wahl Sc an 1.1 I/O-Owner, nic ht relevant @ 8\mod_1280825905093_21.doc x @ 61996 @ @ 1

•

I/O owner assignment

Here you can specify to which process image (e.g., fieldbus) an I/O module

should belong (irrelevant for this fieldbus coupler).

Pos : 55.5 /Serie 767 (WAGO-SPEED WAY)/Par ametrieren/F eldbus koppler /Aus wahl Sc an 1.2 Diagnos e+Ser vice @ 8\mod_1280825894405_21.doc x @ 61992 @ @ 1

•

Diagnostics setup

Here you can enable or disable synchronous diagnostics and diagnostic

confirmation of the I/O modules, as well as the integrated digital inputs of

the fieldbus coupler.

•

Service page

You can use the Service page to restore the default state for selected 767

components.

Pos : 55.6 /Serie 767 (WAGO-SPEED WAY)/Par ametrieren/F eldbus koppler /Aus wahl Sc an 2.1 Benutz er v.+D ateis ys tem, rel evant @ 8\mod_1279538445358_21.doc x @ 60435 @ @ 1

•

User management

In the user management, you can change the preset passwords (see section

"User Management") for the guest, user and admin users. In addition, you

can reset all passwords to their default state.

•

File system

Here you administer the file system of the fieldbus coupler.

Pos : 55.7 /Serie 767 (WAGO-SPEED WAY)/Par ametrieren/F eldbus koppler /Aus wahl Sc an 3 Netz wer k+ Lifelist @ 8\mod_1279533521364_21.doc x @ 60423 @ @ 1

The "Scan" selection from the context menu offers the following options:

•

Set up network

Add all 767 components connected to the PC by the USB cable to the

network view.

•

Life list

Add individual 767 components connected to the PC by the USB cable to

the "Network View".

Pos : 55.8 /Dokumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1

Manual

Version 2.2.0