Table 103: Information About Existing Module Diagnostics; Table 104: Adjustable Parameters Of The Digital Inputs - WAGO -SPEEDWAY 767 Manual

194 Parameterization via WAGOframe

Table 103: Information about existing module diagnostics

Diagnostics
Short circuit/overload
field supply
Low voltage U
Low voltage U
Parameters of Digital Inputs

Table 104: Adjustable parameters of the digital inputs

Parameter
Designation
Input value
Signal inverting
Filter time
Description
The device has detected a short circuit or overload of the field
supply (only possible when field supply is switched on).
If an undervoltage of the logic or sensor supply (U
LS
occurs on the device, a corresponding diagnostic message is
generated and the F-LED illuminates. The substitute value strategy
that you have parameterized is used on the digital inputs.
If an undervoltage of the actuator supply (U
A
the device, a corresponding diagnostic message is generated and the
F-LED illuminates. The undervoltage of the actuator supply has no
functional effect on the device.
Description
Electronic marking field
(max. 40 characters).
The current input signal is displayed here. If the "Simulation Input
Value" parameter has been selected, select here the input value that
is to be simulated:
If simulation is switched off*
Checkbox unselected:
Input value (0)
Checkbox selected:
Input value (1)
If simulation is switched on
Checkbox unselected:
Input is simulated with value 0
Checkbox selected:
Input is simulated with value 1
You can invert the currently pending input signal here.
Checkbox unselected*:
Input signal is reproduced in the process image in the same manner
as at the input
Checkbox selected:
Input signal is reproduced in the process image in an inverted
manner
Set the input filter for the measured signals here. You have the
following options:
none
0.1 ms
0.5 ms
3 ms*
15 ms
20 ms
WAGO-SPEEDWAY 767
767-1201 FC PROFINET IO 8DI 24V DC
) of < 18 V occurs on
A
) of < 18 V
LS
Manual
Version 2.2.0