Pos : 55.17 /Alle Serien (Allgemeine M odul e)/Übersc hriften/Neue Ü bersc hriften/Ebene 3System-Update - Übersc hrift 3 @ 11\mod_1327490550039_21.doc x @ 87020 @ 3 @ 1

15.6.7

System Update

Pos : 55.18 /Serie 767 ( WAGO-SPEED WAY)/Parametrier en/F eldbus koppler/Systemupdate allgemein_1 @ 13\mod_1344421457148_21.doc x @ 101620 @ 4 @ 1

15.6.7.1

Notes on System Update

Firmware update for the 767 Series components is performed via system update.

To ensure that the fieldbus node remains consistent and executable after updating

the firmware, system update must be performed for both fieldbus coupler and

connected I/O modules.

Pos : 55.19 /Serie 767 ( WAGO-SPEED WAY)/Wichtige Erläuter ung en/Sic herheits hinweise/Ac htung/Ac htung: Systemupdate 767- 1201 @ 8\mod_1279540714529_21.doc x @ 60450 @ @ 1

System update!

Before performing the system updates it must be ensured in order to avoid any

possible damage to the 767 system:

- The power supply must not be interrupted during system updates.

- The physical fieldbus connection must be exists. To exclude the influence of

the field bus, but no data transmission via the fieldbus may take place

(ACT / LNK LED (s) lights/light green).

Pos : 55.20 /Serie 767 ( WAGO-SPEED WAY)/Parametrier en/F eldbus koppler/Systemupdate allgemein_2 (über USB und ETH ERNET) @ 12\mod_1332929928599_21.doc x @ 92507 @ @ 1

Preconditions for update via USB:

•

You have installed the DTM (759-370) WAGOframe.

•

You have installed the DTM (759-371) WAGO service interface.

•

You have installed the DTM (759-922) USB driver.

•

You have installed the DTM (759-362) system update.

•

Update packages are available for the connected 767 Series components.

Preconditions for update via ETHERNET:

•

You have installed the DTM (759-370) WAGOframe.

•

You have installed the DTM (759-363) WAGO TCP service interface (for

update via ETHERNET).

•

You have installed the DTM (759-362) system update.

•

Update packages are available for the connected 767 Series components.

System Update Procedure

To perform a system update for each 767 Series component, please complete the

following steps:

1. Read 767 components' parameters and save them on your PC.

2. Update 767 Series components' firmware.

3. Rewrite parameters from your PC to the 767 Series components.

4. Set parameters to valid and finish the procedure.

Pos : 55.21 /Serie 767 ( WAGO-SPEED WAY)/Wichtige Erläuter ung en/Sic herheits hinweise/Hinweis/Hi nweis : 767-1201 Hinweis z u IP-Adresse und D evice-N ame @ 12\mod_1336397289987_21.doc x @ 94590 @ @ 1

WAGO-SPEEDWAY 767

767-1201 FC PROFINET IO 8DI 24V DC

Manual

Version 2.2.0

Table of Contents