Pos : 25.28 /Serie 767 ( WAGO-SPEED WAY)/Ansc hluss D aten- und Versorgungs kabel/F eldbus koppler/Ansc hluss _U SB 1 @ 7\mod_1268916382387_21.doc x @ 53560 @ 2 @ 1

6.7

Connecting the USB Cable

The fieldbus coupler's USB connection can be used to either configure the

fieldbus coupler with an FDT/DTM frame application or to use general service

functions. To use the USB connection, the USB driver

"WAGO_767_USB_DRIVER_Setup" (item no.: 759-922) must be installed on

your computer. This driver can be obtained on the Internet at www.wago.com.

Pos : 25.29 /Serie 767 ( WAGO-SPEED WAY)/Ansc hluss D aten- und Versorgungs kabel/F eldbus koppler/Ansc hluss _U SB 2 @ 7\mod_1268918791236_21.doc x @ 53589 @ @ 1

The USB driver is also included on the "WAGOframe" CD-ROM (item no.:

759-370).

Pos : 25.30 /Serie 767 ( WAGO-SPEED WAY)/Ansc hluss D aten- und Versorgungs kabel/F eldbus koppler/Ansc hluss _U SB 3 @ 7\mod_1268918359157_21.doc x @ 53573 @ @ 1

After installing the WAGO USB driver, the following COM port is supplied by

the USB connection:

Pos : 25.31 /Serie 767 ( WAGO-SPEED WAY)/Ansc hluss D aten- und Versorgungs kabel/F eldbus koppler/Ansc hluss _U SB 4 @ 7\mod_1268918486906_21.doc x @ 53579 @ @ 1

• I/O-Service

This COM port is needed to configure the fieldbus coupler using WAGOframe.

Pos : 25.32 /Serie 767 ( WAGO-SPEED WAY)/Wichtige Erläuter ung en/Sic herheits hinweise/Hinweis/Hi nweis : 767-FBK U SB- Ans chl uss @ 8\mod_1279086267121_21.doc x @ 59880 @ @ 1

Communication disruption due to faulty data transmission

When using the USB connection, a faulty USB data transmission or an outage can

cause communication disruptions. This can be due to additional or inappropriate

USB distributors (hubs) or to USB cables that are too long (max. 5 m) or

inappropriate. One should therefore refrain from using additional devices if

possible.

Pos : 25.33 /Serie 767 ( WAGO-SPEED WAY)/Ansc hluss D aten- und Versorgungs kabel/F eldbus koppler/Ansc hluss _U SB 5_1 @ 7\mod_1268918605375_21.doc x @ 53586 @ @ 1

When using a USB cable that has not been pre-assembled, M8 plugs with the

IP 67 degree of protection are to be connected. The following table outlines the

assignment of the USB connection: