Table 7: Explanation Of Dip Switch - WAGO -SPEEDWAY 767 Manual

28 Device Description

Table 7: Explanation of DIP Switch

Switch
1 ... 7
8
9
10
11
12
Detailed information
Detailed information can be found in section "Commissioning" ... > ... "Setting
the PROFINET Station Name".
Pos : 20.26 /D okumentati on allgemei n/Gli ederungsel emente/---Seitenwec hs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
On
These switches are used to set the instance of the station name
for the fieldbus coupler. For the station name to be assigned,
switch 9 must be in the "On" position.
The instance 0 is not visible in the name. The instances 1 ... 127
are separated by a hyphen in the station name.
Switch 8 selects the station name which is to be used for
instantiation of the fieldbus coupler using switches 1 through 7.
You have the choice between two station names. When the
switch is in the "Off" position, the fieldbus coupler loads the
name "wago-767-1201"; when in the "On" position, it loads the
name
"wagox767x1201".
In the "OFF" switch position, the fieldbus coupler loads the
station name saved in the devices retentive memory. The station
name can be changed according to the PROFINET specification
via a PROFINET IO connection to a PROFINET controller or
engineering tool.
No function.
This DIP switch must always be set to "Off".
This switch is used to
initiate a hardware reset of
the fieldbus coupler. You
can override this status by
returning the switch to
"Off".
WAGO-SPEEDWAY 767
767-1201 FC PROFINET IO 8DI 24V DC
Off
Normal operating
Manual
Version 2.2.0