Changing The Bus Address; Figure 49: Opening The "List Of Bus Nodes" Window (Example) - WAGO -SPEEDWAY 767 Manual

162 Parameterization via WAGOframe
Pos : 55.9 /Serie 767 (WAGO-SPEED WAY)/Par ametrieren/F eldbus koppler /Bus adr ess e änder n @ 7\mod_1269257614398_21.doc x @ 53675 @ 3 @ 1
15.6.1

Changing the Bus Address

Requirement: Disconnect the communication link to the fieldbus coupler ("Go
offline" in the context menu).
If you wish to simply configure select I/O modules instead of the entire topology,
add these I/O modules manually to the Network View. For these I/O modules to
be accessible at the correct bus address, you must assign them the correct
addresses. To do so, please proceed as follows:
1. Right-click on the coupler in the "Network View" pane.
2. In the context menu, select Additional Functions > Change bus
addresses. A window opens with a list of the bus nodes.

Figure 49: Opening the "List of Bus Nodes" window (example)

WAGO-SPEEDWAY 767
767-1201 FC PROFINET IO 8DI 24V DC
Manual
Version 2.2.0