Tools And Accessories Required For Mounting - WAGO -SPEEDWAY 767 Manual

WAGO-SPEEDWAY 767
767-1201 FC PROFINET IO 8DI 24V DC
Pos : 23.6 /Serie 767 (WAGO-SPEED WAY)/M ontier en/Fel dbus koppl er/Montage_Wer kz eug 767- xxxx_Fel dbus koppl er @ 7\mod_1268894155891_21.doc x @ 53422 @ 2 @ 1
5.2

Tools and Accessories Required for Mounting

Depending on the mounting type, the following tools are required for installation:
• A screwdriver for M4 fixing screws
• Drilling machine to pre-drill the mounting holes for the fieldbus coupler to
be mounted to the system and, if applicable, for the imperforated carrier rail.
• M4 thread cutter (bottoming tap or hand tap set)
The WAGO accessories listed below are required for mounting. The associated
item numbers can be found in the "Accessories" section.
• Carrier rail adapter, including fixing screws and perforated or imperforated
carrier rails (DIN 35 x 7.5) according to EN 60715, also available from
WAGO.
or
• Profile adapter, including fixing screws
• Spacer (optional)
Three M4x12 screws are required for direct mounting of the fieldbus coupler. The
length of the screw shaft is to be selected according to the mounting type.
Bore measurements
When fastening the 767 Series component without a threaded hole, the clearance
hole must not be wider than 4mm so as to ensure safe contact of the FG
(functional ground) connections.
Pos : 23.7 /Dokumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Manual
Version 2.2.0
Mounting 41