Example Of An Error Message Via Blink Code - WAGO -SPEEDWAY 767 Manual

136 Diagnostics
14.4.2

Example of an Error Message via Blink Code

The following example clarifies an error message as indicated by the blink code.
An S-BUS error is displayed when the software update for the sixth I/O module
fails.
Initialization:
1. The CS LED begins with the initiation of the start phase: quick flashing of
about 1 s
2. A one-second pause occurs.
Group number 1: S-BUS error
3. The CS LED blinks once for the first digit: 0.5 s on and off.
4. The initiation of the error code follows with a pause of two seconds, 40ms
of blinking and another pause of two seconds.
Error code 13: software update for I/O module failed
5. The CS LED blinks once for the first digit.
6. A two-second pause occurs.
7. The CS LED blinks 3 times for the second digit.
8. The initiation of the error argument follows with a pause of two seconds,
40ms of blinking and another pause of two seconds.
Error argument 5: I/O module in the sixth slot
9. The CS LED blinks 5 times for the first digit.
10. A four-second pause occurs.
The blink code starts when the start phase is initiated. This process is repeated if
only one error is present; if more are present, the next pending error is processed.
Pos : 52.13 /D okumentati on allgemei n/Gli ederungsel emente/---Seitenwec hs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
WAGO-SPEEDWAY 767
767-1201 FC PROFINET IO 8DI 24V DC
Manual
Version 2.2.0