ADTRAN OPTI-6100 Installation Manual page 388

OPTI-6100 Installation and Turn-Up Practice
NOTE
Refer to the documentation of the computer system if unsure how
♦
to perform a Ping command. On most computers running a
networked version of Microsoft Windows or UNIX, the Ping
command is simply
Typically the Ping program responds by indicating that the
remote IP Address has either responded in a certain amount of
time or that no response was received.
Some versions of Ping continue running until a termination
♦
command is entered. If the program does not terminate on its
own, press
3. Connect to the SCM through Telnet.
From the same computer used in the previous step, Telnet to the SCM and verify that the
Telnet session is properly opened.
NOTE
Refer to the documentation of the computer system if unsure how
♦
to initiate a Telnet session. On most computers running a
networked version of Microsoft Windows or UNIX, the Telnet
command is simply
Telnet is a utility common on many local area networks that
allows remote access to another computer or piece of equipment.
Some versions of Telnet display these menus in the same window
♦
from which the Telnet command was issued while others open a
separate window to display the Telnet session.
A-12
ping <IP Address>
to stop the program.
Ctrl+C
telnet <IP Address>
at a command prompt.
at a command prompt.
61184500L1-5L