ADTRAN OPTI-6100 Installation Manual page 343

13. To add members to the LCAS group, complete the following steps:
a. From the VCG # Provisioning menu, select
b. From the VCG # LCAS Provisioning menu, select
c. From the LCAS menu, select
A confirmation prompt appears:
A loss of traffic will occur. Are you sure? {Y,N}:
d. Press , and press
Y
e. From the VCG # LCAS Provisioning menu, select
f. Press four times to return to the main Provisioning menu.
E
SC
14. To activate a Flow (to allow Ethernet packets between an Ethernet Port and a VCG),
complete the following procedure:
a. From the Provisioning menu, select
b. From the Flow Provisioning menu, select
c. Enter the Flow Number (1–1000) of the Flow to use, and press
d. From the Flow # Provisioning menu, select
e. From the Flow # Input Selection menu, select
f. From the Flow # Input Selection menu, select the Ethernet port (1–8) to be the input
point for the flow.
g. From the Flow # Provisioning menu, select
h. From the Flow # Uplink Selection menu, select
i. In the Enter VCG Number field, select the VCG port (1–191) to use as the uplink.
j. If a port-based Transparent flow is desired (all packets from an Ethernet port to/from the
VCG), complete
k. From the Flow # Provisioning menu, select
l. From the Flow # Upstream VLAN Mode menu, select
m. From the Flow # Provisioning menu, select
n. From the Flow # Provisioned Service State menu, select
o. From the Flow # Provisioning menu, select
p. From the Flow # Enable State menu, select
Packets may now flow.
q. From the Flow # Provisioning menu, select
r. From the Flow # Provisioned Service State menu, select
Refer to "Appendix C, Advanced Ethernet Provisioning"
provisioning options.
61184500L1-5L
Enabled
.
E
NTER
step k and step l. Otherwise, skip to
, and press
LCAS
, and press
LCAS
, and press
.
E
NTER
Add All Members
, and press
Flow Provisioning
Enter a Flow Number
, and press
Flow Input
Ethernet Selection Menu
, and press
Flow Uplink
Enter VCG Number
step
Up VLAN Mode
Transparent
Prov Serv State
, and press
Enable State
, and press
Enable
Prov Serv State
for more details on various Ethernet
Tributary Module Installation and Turn-Up
.
E
NTER
.
E
NTER
, and press
E
.
E
NTER
, and press
E
NTER
.
E
NTER
.
E
NTER
, and press
.
E
NTER
, and press
E
m.
, and press
.
E
NTER
, and press
E
, and press
.
E
NTER
.
OOS-MA
.
E
NTER
to start the flow.
E
NTER
, and press
.
E
NTER
and press .
IS E
NTER
.
NTER
.
.
E
NTER
.
NTER
.
NTER
317