Ds1Vm2 Provisioning - ADTRAN OPTI-6100 Installation Manual

OPTI-6100 Installation and Turn-Up Practice

DS1VM2 Provisioning

Use this Provisioning procedure to provision the DS1VM2 module (P/N 1184515L4).
To provision the DS1VM2 module, complete the following steps:
1. From the OPTI-6100 Main menu, select
2. From the MS Modules menu, select the DS1VM2 module to provision, and press
3. From the ADTRAN DS1VM2 Line Card menu, select
4. From the Provisioning menu, select
5. From the Equipment Provisioned State menu, select
6. From the Provisioning menu, select
7. From the Facility Provisioning menu, select
8. From the Facility Provisioned State menu, select a DS1 or
9. From the next screen, select
10. From the Facility Provisioning menu, select
NOTE
AINS prevents alarms from being reported on facilities that are not
yet receiving a valid signal. Refer to
11. From the AINS Timer menu, select
12. From the Facility Provisioning menu, select
13. On the AINS Time screen, enter the time in hours and minutes, and press
14. From the Provisioning menu, select
15. From the DS1 Line Length menu, select a DS1 or
16. Select a line length option, and press
17. Press to return to the
E
SC
18. From the Provisioning menu, select
19. From the DS1 Line Coding menu, select a DS1 or
20. From the next screen, select
21. Press to return to the
E
SC
22. From the Provisioning menu, select
23. From the DS1 Loopback Detection menu, select a DS1 or
24. From the next screen, select
25. Press to return to the
E
SC
26. From the Provisioning menu, select
27. From the DS1 Line Identification menu, select the DS1 to be labeled, and press
28. On the next screen, enter the label for the DS1, and press
268
MS Modules
Equipment Provisioned State,
Facility Provisioning
Facility Provisioned State
, and press
IS E
NTER
AINS Timer
"Auto In-Service"
, and press
Enable
AINS Time
DS1 Line Length
.
E
NTER
menu.
Provisioning
DS1 Line Coding
or , and press
AMI B8ZS
menu.
Provisioning
DS1 Loopback Detection
, , or
Disabled CSU NIU,
menu.
Provisioning
DS1 Line Identification
, and press .
E
NTER
, and press
Provisioning
and press
, and press
IS E
NTER
, and press
E
NTER
, and press
Set Multiple
to place the facility IS.
, and press
E
NTER
on page 332.
.
E
NTER
, and press
E
NTER
, and press .
E
NTER
and press
Set Multiple,
, and press .
E
NTER
, and press
Set Multiple
.
E
NTER
, and press
, and press
Set Multiple
and press .
E
NTER
, and press
E
NTER
.
E
NTER
.
E
NTER
.
E
NTER
.
E
NTER
.
.
.
E
NTER
, and press .
E
NTER
.
.
.
E
NTER
.
E
NTER
.
E
NTER
.
E
NTER
.
E
NTER
.
.
E
NTER
61184500L1-5L