OPTI-6100 Installation and Turn-Up Practice
GEFM Provisioning
Use this Provisioning procedure to provision the GEFM module (P/N 1184535L1).
To provision the GEFM module, complete the following steps:
1. From the OPTI-6100 Main menu, select
2. From the MS Modules menu, select the GEFM module to provision, and press
3. From the GEFM Line Card menu, select
4. From the Provisioning menu, select
5. From the Equipment Provisioned State menu, select
6. From the Provisioning menu, select
7. From the Facility Provisioned State menu, select
8. From the Provisioning menu, select
NOTE
AINS prevents alarms from being reported on facilities that are not
yet receiving a valid signal. Refer to
9. From the AINS Timer menu, select
10. From the Provisioning menu, select
11. On the AINS Time screen, enter the number of hours and minutes, and press
Table 156
lists the minimum factory defaults and values that are loaded after installation and
self-test for the GEFM module.
Provisioning Options
Equipment Provisioned State
Facility Provisioned State
EFM Group #1 – 30 Provisioned State
AINS Time
AINS Timer
Refer to
"Appendix C, Advanced Ethernet Provisioning"
provisioning options.
312
MS Modules
Provisioning
Equipment Provisioned State
Facility Provisioned State
AINS Timer
, and press
Enable
AINS Time
Table 156. GEFM Provisioning Options
Settings
IS
♦
♦
OOS-MA
♦
IS
♦
OOS-MA
♦
IS
OOS-MA
♦
1 Minute to 96 Hours; 4:00 is the default
Enabled
♦
, and press
E
NTER
, and press
E
NTER
, and press
and press
IS,
, and press
and press
IS,
E
NTER
, and press
.
E
NTER
"Auto In-Service"
on page 332.
.
E
NTER
, and press
.
E
NTER
♦
♦
♦
♦
for more details on various Ethernet
.
.
E
NTER
.
.
E
NTER
.
E
NTER
.
E
NTER
to place the facility IS.
.
E
NTER
OOS-MA UAS (default)
OOS-MA UAS (default)
OOS-MA UAS (default)
Disabled (default)
61184500L1-5L