Omm3 Module Installation; Figure 137. Omm3Ir (Left), Omm3 Onboard Fiber Routing (Right) - ADTRAN OPTI-6100 Installation Manual

OPTI-6100 Installation and Turn-Up Practice

OMM3 Module Installation

OMM3 modules (OMM3IR illustrated in
the OPTI-6100, converting OC-3 signals into STS-N signals, distributed through the backplane
to the tributary modules.
NOTICE
Electrostatic discharge (ESD) can damage electronic modules.
♦
Before handling modules, wear an antistatic discharge wrist strap
to prevent damage to electronic components. Place modules in
antistatic packing material when transporting or storing. When
working on modules, always place them on an approved antistatic
mat that is electrically grounded.
Inspect all modules prior to installation. If a module has been
♦
damaged during shipping, file a claim with the carrier and contact
ADTRAN Customer Support. Refer to
To avoid pinching the fibers between the module and chassis,
♦
route the fibers through the guides on the module and out along
the top edge of the front panel, as illustrated in

Figure 137. OMM3IR (Left), OMM3 Onboard Fiber Routing (Right)

OMM3 modules plug directly into the MX or SMX chassis in either HS slot, located directly in
the center of the chassis, labeled
NOTE
OMM3 modules are not supported in the LMX chassis.
Features vary between OMM3 modules. For detailed descriptions of
individual modules, refer to the OPTI-6100 Overview, Engineering,
Applications, and Ordering Practice (P/N 61184500L1-7).
224
Figure
OMM3IR
1184502L4
STATUS
ALARM
ONLINE
TEST
and
HS1
137, left) terminate an OC-3 fiber circuit to feed
"Appendix D,
on the bottom edge.
HS2
Warranty".
Figure 137 (right).
61184500L1-5L