Mapping Cross-Connects; Dual-Pane Interface; Figure 171. Omm12 Mapping Menu - ADTRAN OPTI-6100 Installation Manual

MAPPING CROSS-CONNECTS

OMM modules support the provisioning of cross-connects within the OPTI-6100 chassis. To
facilitate the cross-connects, a dual-pane interface allows simultaneous viewing of two different
modules, ports, or both within the OPTI-6100 system. This section presents the operational
considerations of this interface.

Dual-Pane Interface

The dual-pane interface occurs automatically when the Mapping option is selected. To begin
dual-pane mapping, perform the steps below:
1. From the OPTI-6100 Main menu, select
NOTE
Cross-connects for OMM modules can be mapped from either OMM.
2. From the OMM module menu, select
3. From the Provisioning menu, select
Figure 171 illustrates a sample Mapping menu.
TID: PHX-JMR
Unacknowledged Alarms: None
4. Select a Mapping option to map cross-connects for the level and HS slot specified.
The Mapping screen is divided into two identical halves. These are the dual panes, which
are identical and completely interchangeable. It does not matter which side is used.
61184500L1-5L
HS1
Provisioning
, and press
Mapping
OPTI-6100 System
Mapping
1. HS1 STS-3C Mapping
2. HS2 STS-3C Mapping
3. HS1 STS-1 Mapping
4. HS2 STS-1 Mapping
5. HS1 VT Mapping
6. HS2 VT Mapping
8. View Mappings
10. STS-3C Passthrough
11. STS-1 Passthrough
12. VT Passthrough
14. Map Preference
Selection:
'?' - System Help Screen

Figure 171. OMM12 Mapping Menu

or , and press
HS2 E
NTER
, and press
E
NTER
.
E
NTER
MM/DD/YY HH:MM
Chassis: 1
: Always Protected
Mapping Cross-Connects
.
.
Slot: HS
337