Ds3M3E Provisioning - ADTRAN OPTI-6100 Installation Manual

OPTI-6100 Installation and Turn-Up Practice

DS3M3E Provisioning

Use this Provisioning procedure to provision the DS3M3E module (P/N 1184533L2).
To provision the DS3M3E module, complete the following steps:
1. From the OPTI-6100 Main menu, select
2. From the MS Modules menu, select the DS3M3E module to provision, and press
3. From the ADTRAN DS3 Line Card menu, select
4. From the Provisioning menu, select
5. From the Equipment Provisioned State menu, select
6. From the Provisioning menu, select
7. From the Facility # Provisioning menu, select
8. From the Provisioned State menu, select
9. Repeat step 6 through
10. From the Provisioning menu, select
NOTE
AINS prevents alarms from being reported on facilities that are not
yet receiving a valid signal.
On the DS3M3E, AINS Timer and DS3 Framing are Enabled by
default. Refer to
Format Detection"
11. On the AINS Time screen, enter the number of hours and minutes, and press
12. From the Provisioning menu, select
13. From the Board Operating Mode menu, select
14. From the Provisioning menu, select
15. From the Line Build Out menu, select
282
MS Modules
Equipment Provisioned State
Facility # Provisioning
IS
step 8 for each remaining facility.
AINS Time
"Auto In-Service"
on page 333 for details.
Board Operating Mode
Line Build Out
Short
, and press
E
, and press
Provisioning
, and press
and press
IS,
, and press
, and press
Provisioned State
, and press to place the facility IS.
E
NTER
, and press .
E
NTER
on page 332 and
, and press
or , and press
DS3 EC1
, and press
E
NTER
or , and press
Long E
.
NTER
E
NTER
.
E
NTER
.
E
NTER
.
E
NTER
.
E
NTER
.
E
NTER
"Auto Frame
E
NTER
.
E
NTER
.
E
NTER
.
.
NTER
61184500L1-5L
.
.