OPTI-6100 Installation and Turn-Up Practice
OMM3 and OMM12 Mappings
The topics in this section are as follows:
"Creating a New STS-3c Mapping"
♦
"Creating a New STS-1 Mapping"
♦
"Creating a New VT1.5 Mapping"
♦
NOTE
Mapping screens differ on the OMM48 and OMM48L, which support
STS-12c mappings. Refer to
information regarding cross-connects on OC-48 modules.
Creating a New STS-3c Mapping
To create a new STS-3c Mapping, follow the procedures below:
1. Enter the Mapping screen.
For more information refer to
2. Highlight an unmapped tributary module in one pane.
3. Switch to the other pane.
4. Highlight an unmapped HS1 STS-3c, and press
The
STS3c Mapping Action
TID: PHX-JMR
Unacknowledged Alarms:
The STS3C Mapping Action menu lists the possible actions. If an action cannot be
selected, the line is unnumbered, and the action is followed by a brief explanation of why
the action is unavailable. In the example above, only option
342
on page 342
on page 344
on page 346
"Dual-Pane Interface"
menu
(Figure
OPTI-6100 System
STS3C Mapping Action
Create One-Way Mapping : <One-way reverse mappings not supported>
2. Create Two-Way Mapping :
Delete One-Way Mapping : <Item is not mapped>
Delete Two-Way Mapping : <Item is not mapped>
Delete Broadcast
'?' - System Help Screen
Figure 173. STS3C Mapping Action Menu
"OMM48 Mappings"
on page 337.
.
E
NTER
173) appears.
: <Item is not broadcasting>
Selection:
on page 347 for
MM/DD/YY HH:MM
Chassis: 1
Slot: HS1
is selectable.
2
61184500L1-5L