ADTRAN OPTI-6100 Installation Manual page 361

8. Press to return to the
E
SC
9. From the SONET DCC Provisioning menu, select
10. From the DCC Interfaces menu, press
This brings up a list of available facilities to which a DCC interface may be assigned.
11. Select the MS slot and port number to which the DCC interface is to be assigned.
Once the DCC interface has been created, the
provision the specific interface.
12. From the DCC Interface Provisioning menu, select
13. Enter a name that describes the downstream system, and press
14. From the DCC Interface Provisioning menu, select
15. From the DCC Mode menu, select the
NOTE
When creating a DCC link, one end of the link must be set to
Network and the other to User. It is not important which is which.
16. From the DCC Interface Provisioning menu, select
17. From the Service State menu, select
61184500L1-5L
SONET DCC Provisioning
to create a new DCC interface.
C
or
Network
to place the DCC In Service, and press
IS
Tributary Module Installation and Turn-Up
menu.
DCC Interface Provisioning
DCC Interface Provisioning
, and press
Name
E
NTER
, and press
DCC Mode
, and press
User E
NTER
, and press
Service State
, and press
E
NTER
menu appears to
.
E
NTER
.
.
E
NTER
.
.
E
NTER
.
E
NTER
335
.