Gigabit Ethernet Module Provisioning; Gecm Provisioning - ADTRAN OPTI-6100 Installation Manual

Gigabit Ethernet Module Provisioning

Each tributary module has its own Provisioning menu tree. This section highlights some of the
items in the GigE module menu trees needed to provision a new module. Refer to
Advanced Ethernet Provisioning"
The topics in this section include:

"GECM Provisioning"

♦
"GESM or GEMM Provisioning"
♦
"GEFM Provisioning"
♦
"PWE3M Provisioning"
♦
"GEFMEH Provisioning"
♦
"GEFMEW Provisioning"
♦
GECM Provisioning
Use this Provisioning procedure to provision the GECM module (P/N 1184516L1).
To provision the GECM module, complete the following steps:
1. From the OPTI-6100 Main menu, select
2. From the MS Modules menu, select the GECM module to provision, and press
3. From the GECM Line Card menu, select
4. From the Provisioning menu, select
5. From the Equipment Provisioned State menu, select
6. From the Provisioning menu, select
7. From the Facility Provisioned State menu, select
8. From the Provisioning menu, select
NOTE
AINS prevents alarms from being reported on facilities that are not
yet receiving a valid signal. Refer to
9. From the AINS Timer menu, select
10. From the Provisioning menu, select
11. On the AINS Time screen, enter the number of hours and minutes, and press
61184500L1-5L
for more in-depth Ethernet provisioning.
on page 309
on page 311
on page 312
on page 313
on page 314
on page 316
MS Modules
Provisioning
Equipment Provisioned State
Facility Provisioned State
AINS Timer
, and press
Enable
AINS Time
Tributary Module Installation and Turn-Up
, and press
E
NTER
, and press
E
NTER
, and press
and press
IS,
, and press
, and press
IS E
NTER
, and press .
E
NTER
"Auto In-Service" on page 332.
.
E
NTER
, and press .
E
NTER
"Appendix C,
.
.
E
NTER
.
.
E
NTER
.
E
NTER
.
E
NTER
to place the facility IS.
.
E
NTER
309