Table 149. Ethm/Ethm2 Provisioning Options - ADTRAN OPTI-6100 Installation Manual

d. From the Port # Provisioning menu, select
e. From the Duplex menu, select either
Half Duplex Only
f. From the Port # Provisioning menu, select
If Speed is set to Auto Negotiate, select
◊
If Speed is not set to Auto Negotiate, and a crossover cable is required, select
◊
NOTE
Auto Crossover eliminates the need to have both straight and
crossover cables.
11. To set the Facility service state, complete the following procedure:
a. From a Port Provisioning menu, select
b. From the Facility Provisioning menu, select
Table 149 lists the minimum factory defaults and values that are loaded after installation and
self-test for the ETHM/ETHM2 modules.
Provisioning Options
Equipment Provisioned State
Port #1 – 3 Provisioned State
AINS Time
AINS Timer
Speed
Duplex
Crossover
Refer to "Appendix C, Advanced Ethernet Provisioning"
provisioning options.
61184500L1-5L
, and press .
E
NTER

Table 149. ETHM/ETHM2 Provisioning Options

, and press
Duplex
(the default, recommended mode) or
Full Duplex/Auto
, and press
Crossover
, to enable Auto-detect.
None/Auto
Facility Provisioning
, and press
IS
Settings
♦ IS
OOS-MA
♦
OOS-MA UAS (default)
♦
IS
♦
♦ OOS-MA
OOS-MA UAS (default)
♦
1 Minute to 96 Hours; 4:00 is the default
Enabled
♦
♦ Disabled (default)
♦ Auto Negotiate (default)
♦ 10 Mbps
100 Mbps
♦
Full Duplex/Auto (default)
♦
♦ Half Duplex Only
♦ None/Auto (default)
Forced
♦
for more details on various Ethernet
Tributary Module Installation and Turn-Up
.
E
NTER
.
E
NTER
, and press .
E
NTER
.
E
NTER
.
Forced
293