Sfp Installation; Table 161. Sfps Supported On The O3Tme - ADTRAN OPTI-6100 Installation Manual

SFP Installation

If installing an O3TME or O12TME, install the required SFP into the SFP cage, according to the
following steps:
1. Insert an SFP into the SFP cage, with the release bail facing outward.
2. Slide the SFP all the way into the SFP cage.
3. Using thumb and forefinger, firmly squeeze the SFP and module together, to ensure a
proper connection.
Table 161 lists the SFPs supported on the O3TME.
Table 162 on page 326 lists the FPs supported by the O12TME.
SFP Part Number
OC-3 SFPs
SFP3L 1184543P1
SFP3I 1184543P2
SFP3M 1184543P3
SFP3L2 1184543P5
OC-3 CWDM SFPs
SFP3C1 1442701PG1
SFP3C2 1442701PG2
SFP3C3 1442701PG3
SFP3C4 1442701PG4
SFP3C5 1442701PG5
SFP3C6 1442701PG5
SFP3C7 1442701PG7
SFP3C8 1442701PG8
OC-3 Bi-Directional SFPs
SFP3B1 1442702PG1
SFP3B2 1442702PG2
* = For CWDM and single-fiber/BiDi applications, refer to the OPTI-6100 Overview, Engineering, Applications, and
Ordering Practice (P/N 61184500L1-7).
61184500L1-5L

Table 161. SFPs Supported on the O3TME

Specifications
Long Reach-1 (1310 nm), single-mode
Intermediate Reach, single-mode
Multi-mode
Long Reach-2 (1550 nm), single-mode
CWDM, 1471 nm
CWDM, 1491 nm
CWDM, 1511 nm
CWDM, 1531 nm
CWDM, 1551 nm
CWDM, 1571 nm
CWDM, 1591 nm
CWDM, 1611 nm
Single-fiber, 1310 nm Tx/1550 nm Rx
Single-fiber, 1550 nm Tx/1310 nm Rx
Tributary Module Installation and Turn-Up
Notes
CWDM SFPs are used in
Coarse-Wavelength Division
Multiplexing applications*.
BiDi SFPs are used in
single-fiber applications*.
325