Ds1Vmt Provisioning - ADTRAN OPTI-6100 Installation Manual

DS1VMT Provisioning

Use this Provisioning procedure to provision the DS1VMT module (P/N 1184515L3).
To provision the DS1VMT module, complete the following steps:
1. From the OPTI-6100 Main menu, select
2. From the MS Modules menu, select the DS1VME module to provision, and press
3. From the ADTRAN DS1VMT Line Card menu, select
4. From the Provisioning menu, select
5. From the Equipment Provisioned State menu, select
6. From the Provisioning menu, select
7. From the Facility Provisioning menu, select
8. From the Facility Provisioned State menu, select a DS1 or
9. From the next screen, select
10. From the Facility Provisioning menu, select
NOTE
AINS prevents alarms from being reported on facilities that are not
yet receiving a valid signal.
On the DS1VMT, AINS Timer and DS1 Framing are Enabled by
default. Refer to
Format Detection"
11. On the AINS Time screen, enter the number of hours and minutes, and press
12. Press to return to the Provisioning menu.
E
SC
13. From the Provisioning menu, select
14. From the Line Length menu, select a DS1 or
15. From the next menu, select a line length option, and press
16. Press to return to the Provisioning menu.
E
SC
17. From the Provisioning menu, select
18. From the Line Coding menu, select a DS1 or
19. From the next menu, select
20. Press to return to the Provisioning menu.
E
SC
21. From the Provisioning menu, select
22. From the Loopback Code Detection menu, select a DS1 or
23. From the next menu, select
24. Press to return to the Provisioning menu.
E
SC
25. From the Provisioning menu, select
26. From the Line Identification menu, select the DS1 to be labeled, and press
61184500L1-5L
MS Modules
Equipment Provisioned State,
Facility Provisioning
Facility Provisioned State
, and press
IS E
NTER
AINS Time
"Auto In-Service" on page 332 and
on page 333 for details.
, and press
Line Length
Set Multiple,
, and press
Line Coding
Set Multiple
or , and press
AMI B8ZS
Loopback Detection
, , or
Disabled CSU NIU,
Line ID (1 to 14)
Tributary Module Installation and Turn-Up
, and press .
E
NTER
, and press
Provisioning
and press
, and press
IS E
NTER
, and press
E
NTER
, and press
Set Multiple
to place the facility IS.
, and press
E
NTER
"Auto Frame
.
E
NTER
and press
E
NTER
.
E
NTER
.
E
NTER
, and press
E
NTER
.
E
NTER
, and press
E
NTER
Set Multiple
and press .
E
NTER
or , and press
(15 to 28)
.
E
NTER
.
E
NTER
.
E
NTER
.
.
.
E
NTER
, and press .
E
NTER
.
.
E
NTER
.
.
.
, and press .
E
NTER
.
E
NTER
.
E
NTER
265