Fiber Connection and Routing
Identify the fiber conductors to be terminated on the GigE module, and insert the connectors
into the
or
jacks as appropriate.
IN
OUT
NOTICE
The clips on the GEFMEH module permit fibers up to 2×2 mm.
♦
To avoid pinching fibers between the GEFM, PWE3M, or GEFMEH
♦
module faceplate and the edge of the chassis, route the fibers
through the guides on the module and out along the top edge of
the front panel, as illustrated in
Figure 164. Onboard Fiber Routing: GEFM, PWE3M (Top), and GEFMEH (Bottom)
NOTE
The GEFMEW module uses front-access fiber termination. Onboard
fiber routing does not apply.
61184500L1-5L
Tributary Module Installation and Turn-Up
Figure
164.
307