Multi-Rate Omm Module Provisioning - ADTRAN OPTI-6100 Installation Manual

OPTI-6100 Installation and Turn-Up Practice

Multi-Rate OMM Module Provisioning

The OMM312V module must be provisioned to be put into service. In particular, equipment and
facilities must be put into service, STS circuits must be assigned to the equipped mid-speed
groups, and the SONET data rate selected to reflect the installed SFP.
To provision the OMM312V module, complete the following steps:
1. From the OPTI-6100 Main menu, select
NOTE
These instructions are for the module in slot HS1. With the exception
of the STS mapping, these settings must be repeated for HS2.
2. From the OMM312V menu, select
3. From the Provisioning menu, select
4. From the Service States menu, select
5. From the Equipment menu, select
6. From the Service States menu, select
7. From the Facility menu, select
8. From the Service States menu, select
NOTE
AINS prevents alarms from being reported on facilities that are not
yet receiving a valid signal. Refer to
9. From the AINS Timer menu, select Enable, and press
10. From the Service States menu, select
11. On the AINS Time screen, enter the number of hours or minutes, and press
NOTE
Placing a facility IS automatically places its paths IS. To change the
service state of a path, complete the following three steps:
12. From the Service States menu, select the Path to put In Service, and press
13. From the Path Service State menu, select a Path, and press
14. From the Path [n] menu, select
15. If provisioning at the VT level, select
16. From the VT Service States menu, select the VT to place In Service, and press
17. From the VT [n] menu, select
18. Press the appropriate number of times to return to the Provisioning menu.
E
SC
244
HS1 - [module type]
, and press
Provisioning
, and press
Service States
, and press
Equipment
, and press
IS E
, and press
Facility
, and press
IS E
NTER
, and press
AINS Timer
"Auto In-Service"
, and press
AINS Time
, and press
IS E
NTER
VT Service States
, and press to place the VT In Service.
IS E
NTER
, and press
E
.
E
NTER
.
E
NTER
.
E
NTER
to place the module IS.
NTER
.
E
NTER
to place the facility IS.
.
E
NTER
on page 332.
.
E
NTER
.
E
NTER
.
E
NTER
to place the Path In Service.
, and press .
E
NTER
.
NTER
.
E
NTER
.
E
NTER
.
E
NTER
61184500L1-5L