Transmux Module Provisioning; Tram Provisioning - ADTRAN OPTI-6100 Installation Manual

OPTI-6100 Installation and Turn-Up Practice

Transmux Module Provisioning

Each tributary module has its own Provisioning menu tree. This section highlights some of the
items in the transmux module menu trees needed to provision a new module.
The topics in this section include:

"TRAM Provisioning"

♦
"TRAM3 Provisioning"
♦
TRAM Provisioning
Use this Provisioning procedure to provision the TRAM module (P/N 1184512L1).
To provision the TRAM module, complete the following steps:
1. From the OPTI-6100 Main menu, select
2. From the MS Modules menu, select the TRAM module to provision, and press
3. From the TRAM Line Card menu, select
4. From the Provisioning menu, select
5. From the Equipment Provisioned State menu, select
6. From the Provisioning menu, select
7. From the Facility Provisioned State menu, select
8. From the Provisioning menu, select
NOTE
AINS prevents alarms from being reported on facilities that are not
yet receiving a valid signal. Refer to
9. From the AINS Timer menu, select
10. From the Provisioning menu, select
11. On the AINS Time screen, enter the number of hours and minutes, and press
12. From the Provisioning menu, select
13. From the Line Build Out menu, select
320
on page 320
on page 322
MS Modules
Provisioning
Equipment Provisioned State
Facility Provisioned State
AINS Timer
, and press
Enable
AINS Time
Line Build Out
Short
, and press
E
, and press
E
NTER
, and press
and press
IS,
, and press
and press
IS, E
NTER
, and press .
E
NTER
"Auto In-Service" on page 332.
.
E
NTER
, and press .
E
NTER
, and press
E
NTER
or , and press
Long E
.
NTER
E
NTER
.
.
E
NTER
.
E
NTER
.
E
NTER
to place the facility IS.
E
NTER
.
.
NTER
61184500L1-5L
.
.