OPTI-6100 Installation and Turn-Up Practice
Cross-Connect Module Provisioning
The OMMXCV module must be provisioned to be put into service. In particular, equipment and
facilities must be put into service, and STS circuits assigned to the equipped mid-speed groups.
To provision the OMMXCV module, complete the following steps:
1. From the OPTI-6100 Main menu select
2. From the ADTRAN OMMXCV menu, select
3. From the Provisioning menu, select
4. From the Equipment menu, select
The screen automatically reverts to the Provisioning menu.
5. From the Provisioning menu, select
6. From the Mapping menu, select
Quick Access: These menus operate in the same fashion as the Mapping menus on the
♦
OMM12 modules. Refer to
Create Mapping: Manually create a mapping.
♦
Table 135
lists the minimum factory defaults and values that are loaded after installation and
self-test for the OMMXCV module.
Provisioning Options
Service States
Clock Switch Mode
Clock Source
Clock Out
Clock Out Mode
Clock Output LBO
Clock Output Type
Clock Output Source
Clock Out Source
Mapping
248
Equipment Provisioned State
, and press
IS
Mapping
Create Mapping
"Mapping Cross-Connects"
Table 135. OMMXCV Provisioning Options
Settings
IS
♦
OOS-MA
♦
Auto Switch PRI/SEC (default)
♦
♦
PRI Only
Refer to
"OMM Module Clock Source Settings"
♦
Enable
Dual Output from Chassis (default)
♦
0 – 133 ft. (default)
♦
134 – 266 ft.
♦
♦
267 – 399 ft.
♦
DS1 SF (default)
♦
Internal Clock
Ext Clock In
♦
Out PRI = PRI, Out SEC = SEC (default)
♦
Out PRI & SEC = Clock Source
♦
, and press
HS[#] - [OMMXCV]
, and press
Provisioning
to place the module In Service.
E
NTER
, and press
E
NTER
or
Quick Access
on page 337 for further details.
.
E
NTER
.
E
NTER
, and press
.
E
NTER
.
and press
.
E
NTER
OOS-MA UAS (default)
♦
SEC Only
♦
on page 249.
♦
Disable (default)
Single Output from Chassis
♦
400 – 533 ft.
♦
534 – 655 ft.
♦
♦
DS1 – ESF
♦
Trib Module (default)
Out PRI & SEC = PRI
♦
Out PRI & SEC = SEC
♦
61184500L1-5L