About The Message Display - Kenwood NX-5000 Series Common Function Reference

17 STRUCTURING A MULTI RF DECK/ MULTI CONTROL HEAD

17.12 About the Message Display

17.12 About the Message Display
While building a Multi RF Deck/ Multi Control Head system, the messages that appear in the FPU are as follows:
Message
"Do you wish to save the changed
data?" (Yes/ No/ Cancel)
"The Multi RF Deck common
functions of the RF Deck Data
configured in Master Operation
Data will be applied to other RF
Deck Data." (OK/ Cancel)
"If you start "Write Data to the
transceiver", P25 Encryption Key
data will be cleared." (OK/ Cancel)
"The system structure of the data to
be written differs from the system
structure of the Multi RF Deck or
Control Head. For this reason,
some functions do not work. Do you
wish to continue?" (OK/ Cancel)
"Do you wish to save the written
data?" (Yes/ No/ Cancel)
Note
Refer to the service manual for the content of messages that appear on the transceiver display and how to manage when
a message appears.
Common FUNC (K, F)/Ver 2.20
Table 17-1 Message Display
This message is displayed if Multi RF Deck Setup is opened while editing the
configuration data of Multi RF Deck in a screen of KPG-D1/ D1N.
Click the "Yes" button to store the configuration data. If the "No" button is clicked, the
configuration data is not stored.
Clicking the "Write" button in Multi RF Deck Setup displays this message.
Clicking the "OK" button expands the common configuration in the configuration data
configured in Master Operation Data to the data of other RF Decks. Because the
configuration data cannot be written in Multi RF Deck unless the common
configuration is expanded to all RF Decks, clicking the "OK" button is required.
If Zeroize is enabled in Write Data to the Transceiver, clicking the "Write" button
displays this message.
Clicking the "OK" button starts the writing of the configuration data.
When attempting to write configuration data to the transceiver not connected to
Control Head 1, or when attempting to write the data configured in Control Head 2
(Product Information > Control Head Configuration) to the transceiver not
connected to Control Head 2, this message appears.
After writing configuration data in an RF Deck, this message appears.
The configuration contents of configuration data are automatically changed for each
RF Deck by the common configuration in the configuration data configured in Master
Operation Data being expanded to the configuration data of each RF Deck.
Therefore, this message appears.
Click the "Yes" button to store the configuration data. If the "No" button is clicked, the
configuration data is not stored.
Description
CONTENTS
386
INDEX