Kenwood NX-5000 Series Common Function Reference page 257

11 EXTERNAL PORTS
11.3 Selecting the Audio Input Line If Detaching and Using Control Head (Control Head Mic Input)
11.3 Selecting the Audio Input Line If Detaching and Using Control
Head (Control Head Mic Input)
Control Head Mic Input is the function to select whether to input audio from the microphone connected to 8 Pin Modular
Jack of Control Head or from the MIC Input side of the connection cable (KCT-72).
By using KRK-15B and KRK-14H, the Control Head and RF Deck (transceiver) can be separated. If Control Head and RF
Deck are used separately, a microphone can be connected to 8 Pin Modular Jack of Control Head, or a microphone can be
connected to KRK-14H via KCT-72. At this time, configuring whether to input audio from the microphone connected to 8
Pin Modular Jack or from the Mic Input of KCT-72 is required.
As in the case of the following diagram, select whether to input audio from KMC-27 (Microphone) connected to 8 Pin Modular
Jack or from KCT-73MIC (External Mic) connected via KCT-72.
RF Deck
Configuration
Modular Jack Inputs audio from the microphone connected to the Modular Jack.
KCT-72 Inputs audio from the Mic Input of KCT-72.
Note
This function can be used only if KCH-19 (Basic Panel) or KCH-20R (Featured Panel) is used.
Configuration using KPG-D1/ D1N
Configuring Control Head Mic Input (
Common FUNC (K, F)/Ver 2.20
KCT-71
KCT-73MIC
(External Mic)
Figure 11-2 Control Head Mic Input
Table 11-11 Control Head Mic Input
Description
Transceiver Settings > Extended Function > Mobile > Modulation Line)
KMC-27
(Microphone)
CONTENTS INDEX
226