Direct Channel - Kenwood NX-5000 Series Common Function Reference

3 BASIC OPERATIONS
3.5 Changing the Zone-channel
2
Press the Home Channel
A Key Beep B (2 beeps) sounds from the transceiver, and then the
transceiver returns to the previous channel.
0
Changing the Home Channel
1
Select the channel to be configured as the Home Channel.
2
Press the Home Channel Select
A Key Beep C (3 beeps) sounds from the transceiver, and then the Home
Channel is changed. "Home" appears on the display at the same time.
Configuration using KPG-D1/ D1N
0
Configuring Home Channel (
0
Assigning functions to the PF keys on the transceiver (

Direct Channel

Direct Channel is the function to migrate the transceiver to a preconfigured channel by pressing one of the Direct Channel
1 to Direct Channel 5 keys. The transceiver can move to and from channels in each zone.
Also, pressing one of the Direct Channel 1 Select to Direct Channel 5 Select keys can change the Direct Channel.
Or, pressing the Menu key causes the transceiver to enter Menu Mode, and then the Direct Channel can be changed by
selecting one of "Direct Channel 1 Select" to "Direct Channel 5 Select". (Refer to
Note
If the Return function is enabled, pressing one of the Direct Channel 1 to Direct Channel 5 keys during the scan pauses
scanning while the transceiver is migrating to the Direct Channel, and then a Scan Stop Tone (2 beeps) continuously
sounds from the transceiver at 30-sec intervals.
Common FUNC (K, F)/Ver 2.20
key again.
key.
Transceiver Settings > Zone/Channel > Zone Edit > General)
Transceiver Settings > Key Assignment)
Using Menu
CONTENTS
12 : 34 A
M
Z o n e 1
C h a n n e l 1 5
M en u Zo ne+
12 : 34 A
M
Z o n e 1
C h a n n e l 1 5
M en u Zo ne+
12 : 34
A
M
H o m e
Z o n e 1
C h a n n e l 1 5
M en u Zo ne+
Mode.)
46
INDEX