Kenwood NX-5000 Series Common Function Reference page 34

1 FUNCTIONS AND PANEL LAYOUT
1.2 NX-5700/ NX-5800/ NX-5900
1.2 NX-5700/ NX-5800/ NX-5900
KCH-19 (Basic Panel)
6
7
Figure 1-2 NX-5700/ NX-5800/ NX-5900 Front View (KCH-19 (Basic Panel))
A
[P] (Power) Switch
The transceiver is turned ON when this switch is pressed
and the transceiver is turned OFF when this switch is
pressed again. In this manual, the [P] (Power) switch is
described as the Power switch.
[+]/ [-] Key
B
The preassigned function will be activated or will be
changed to the active state. It is normally used for the
volume adjustment of the speaker.
LCD
C
The channel number and the transceiver's status appear
on this display.
D
[G]/ [H] Key
The preassigned function will be activated or will be
changed to the active state. It is normally used to change
the zone or channel.
Speaker
E
The received audio and the Alert Tone sound from the
speaker.
Transmit LED/ Busy LED
F
These LEDs light when the transceiver transmits or
receives a signal.
Illumination Sensor
G
The sensor is for automatically adjusting the luminance
of the LCD depending on the brightness of the
environment.
H
[T] (Home) Key
The preassigned function will be activated or will be
changed to the active state. In this manual, the [T]
(Home) key is described as the Home ([T]) key.
Common FUNC (K, F)/Ver 2.20
1 2
8 9 10
3 4
11 12 13
I
[Q] (Menu) Key
The preassigned function will be activated or will be
changed to the active state. In this manual, the [Q]
(Menu) key is described as the Menu ([Q]) key.
The default of the [Q] (Menu) key is the Menu function.
If the configuration is changed using KPG-D1/ D1N, a
newly configured function will be activated. Unless the
Menu function is reassigned to the [Q] (Menu) key, Menu
Mode cannot be activated even if the [Q] (Menu) key is
pressed.
J
[O] (Back) Key
The preassigned function will be activated or will be
changed to the active state. In this manual, the [O]
(Back) key is described as the Back ([O]) key.
K
[E]/ [F] Key
The preassigned function will be activated or will be
changed to the active state. It is normally used to change
the zone or channel.
L
[W] (Function) Key
The preassigned function will be activated or will be
changed to the active state. In this manual, the [W]
(Function) key is described as the Function ([W]) key.
AUX Key
M
The preassigned function will be activated or will be
changed to the active state.
CONTENTS
5
INDEX
3