About Configuration Using Kpg-D1/ D1N - Kenwood NX-5000 Series Common Function Reference

17 STRUCTURING A MULTI RF DECK/ MULTI CONTROL HEAD
17.10 Troubleshooting in Single RF Deck/ Single Control Head
17.10 Troubleshooting in Single RF Deck/ Single Control Head
If "FIRMWARE PROG" or "FIRM MISMATCH" appears on the display in a system of a Single RF Deck/ Single Control Head
structure, the firmware of the RF Deck and the firmware of the Control Head are different. In this case, write the firmware
with the Control Head connected. If firmware is written from the Control Head with the Control Head connected, the same
firmware is written to the RF Deck and the Control Head, and the transceiver behaves normally.
17.11

About Configuration Using KPG-D1/ D1N

This section describes the configurations in KPG-D1/ D1N for changing an RF Deck/ Control Head structure, and for
switching an RF Deck and a Control Head.
Configuration in KPG-D1/ D1N If Changed from a Single RF Deck Structure to a Multi
RF Deck System
1
Configure the configuration related to the RF Deck and Control Head to be switched in
Information.
0
Multi RF Deck is enabled in Feature Selection.
0
Each Control Head to be used is configured in Control Head 1 and Control Head 2 of Control Head
Configuration.
Common FUNC (K, F)/Ver 2.20
Figure 17-74 Product Information
Product
CONTENTS INDEX
378